ZyXEL Communications Internet Security Gateway ZyWALL 100 - Manual (Page 84)

ZyWALL 100 Internet Security Gateway
Remote Node Setup 9-1
Chapter 9
Remote Node Setup
This chapter shows you how to configure a remote node.
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. Note that when you use menu 4 to set up
Internet access, you are actually configuring a remote node. The following describes how to configure
Menu 11.1 Remote Node Profile, Menu 11.3 - Remote Node Network Layer Options and Menu 11.5 -
Remote Node Filter.
9.1 Remote Node Setup
From the main menu, select menu option 11 to open Menu 11 Remote Node Setup (shown below).
Then enter 1 to open Menu 11.1 Remote Node Profile and configure the setup for your regular ISP. Enter
2 to open Menu 11.1 Remote Node Profile (Backup ISP) and configure the setup for your Dial Backup
port connection (see the Backup Remote Node Setup chapter).
Figure 9-1 Menu 11 Remote Node Setup
Menu 11 - Remote Node Setup
1. ChangeMe (ISP, SUA)
2. ________
Enter Node # to Edit: