ZyXEL Communications Internet Security Gateway ZyWALL 100 - Manual (Page 108)

ZyWALL 100 Internet Security Gateway
Backup Remote Node Setup 10-9
Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote
node and the ZyWALL to prevent certain packets from triggering calls. You can specify up to four filter
sets separated by commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces are accepted in this
field. Please refer to the Filters chapter for more information on defining the filters. With PPPoE and PPTP
encapsulations you also have the option of specifying remote node call filter sets.
Figure 10-6 Menu 11.5 — Remote Node Filter (Ethernet)
Figure 10-7 Menu 11.5 — Remote Node Filter (PPPoE or PPTP)
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL: