Zoom MRS-1266 - Manual (Page 20)

Listening to the Demo Song
ZOOM MRS-1266
20
Playing the demo song
After loading, play the demo song as follows.
1.
Turn down the volume of the audio system.
When headphones are connected, turn down the [MASTER
PHONES] level control.
2.
Press the PLAY [ R ] key in the transport section.
Playback of the demo song starts.
3.
Adjust the audio system volume setting (or the
[MASTER PHONES] level control) to a comfortable
volume.
4.
If you want to adjust the volume of the individual
tracks, use the respective faders.
The volume of the drum sound from the rhythm section can
be adjusted with the [DRUM] fader. If you want to adjust the
volume of the entire song, use the [MASTER] fader.
5.
To switch individual tracks on or off, press the
respective status key.
6.
To stop the demo song, press the STOP [ P ] key.
Turning power off (shutdown)
Whenever you want to turn the MRS-1266 off, be sure to
follow the procedure described below.
1.
Turn power to the audio system off.
2.
Press the [POWER] switch on the rear panel of the
MRS-1266.
If a unprotected project was being used, the state of this
project is automatically saved on the hard disk before the
unit shuts down.
• You must use this method to turn off the power of the
MRS-1266. Never turn off the power by disconnecting
the AC adaptor plug from the [DC 12V] jack or by
unplugging the AC adaptor from the AC power outlet.
• In particular, you must never turn the power off by
unplugging the AC adaptor while the [HDD] indicator
is lit. Doing so may damage the internal hard disk,
causing all data to be lost permanently.
C aution