Zoom MRS-1266 - Manual (Page 145)

Reference [Projects]
ZOOM MRS-1266
145
● If project was backed up as part of a full backup of all
projects
Insert the disc where the project is stored. (If there are
multiple discs, insert the first disc that contains data of the
desired project.)
N OTE
• Also when you have backed up all projects in a single
operation, restore is performed for individual projects.
• If the backup of the project spans multiple discs, be sure
to insert the first disc that contains data of the desired
project first. If you insert another disc, the project data will
not be read correctly.
4.
Press the [ENTER] key.
The name of the project on the disc, and the number which
is to be assigned to the project are shown on the display.
H INT
When being restored to the MRS-1266, an empty project
number is automatically assigned to the project. Even if a
project with the same name already exists on the hard disk,
it will not be overwritten.
5.
To check the name of the directory from which the
project will be read, press the cursor down button.
The display shows the directory name.
Press the cursor up key to restore the original display.
6.
Turn the dial to select the project to load, and press
the [ENTER] key.
The indication “LOAD SURE?” appears on the display.
7.
To execute the load operation, press the [ENTER]
key. To cancel, press the [EXIT] key instead.
When you press the [ENTER] key, the project data are read
from the disc and loaded to the hard disk. When the
operation is finished, the display indication changes to
“LOAD COMPLETE”.
If the backup spans multiple discs, the disc will be
automatically ejected the data have been loaded, and a
message prompting the user to insert the next CD-R/RW disc
appears.
8.
When the above message appears, insert the next
CD-R/RW disc, and press the [ENTER] key.
The load operation resumes. If more than two discs are
required, the above steps will be repeated. When the load
operation is finished, the display indication changes to
“LOAD COMPLETE”.
H INT
When the disc has been ejected, it also possible to abort the
load operation. To do this, press the [EXIT] key while the in-
dication “CHANGE DISCxxx” (where xxx is the disc number)
is shown. The indication will change to “LOAD CANCEL?”.
Press the [ENTER] key to terminate the process.
N OTE
If the backup of the project spans multiple discs, be sure to
insert the discs in the correct order. Otherwise the project
data will not be read correctly.
9.
To return to the main screen, press the [EXIT] key
several times.
7
LOAD LOAD
PRJ012
PRJ012
Project name Project number to
be assigned
7
DirName DirName
PROJ012
PROJ012
Directory name
LOAD LOAD
wait...
wait...
CHANGE CHANGE
DISC002
DISC002