Zoom MRS-1266 - Manual (Page 149)

Reference [MIDI]
ZOOM MRS-1266
149
Specifying transmission of Song
Position Pointer messages
You can specify whether Song Position Pointer messages
will be transmitted. Song Position Pointer is a MIDI
message that indicates the current position as a beat count
from the start. Normally it is used in conjunction with
Timing Clock.
Refer to steps 1 - 4 of “Basic procedure” to bring up the
indication “SPP” on the display. Then turn the dial to select
one of the following settings.
● ON (Transmission on)
MIDI Song Position Pointer messages will be transmitted
when a Locate operation is performed on the MRS-1266
(default setting).
● OFF (Transmission off)
Song Position Pointer messages will not be transmitted.
Specifying transmission of
Start/Stop/Continue messages
You can specify whether Start/Stop/Continue messages will
be transmitted. Start/Stop/Continue are MIDI messages that
control the transport of a device, causing it to run or stop.
Normally these messages are used in conjunction with
Timing Clock.
Refer to steps 1 - 4 of “Basic procedure” to bring up the
indication “COMMAND” on the display. Then turn the dial
to select one of the following settings.
● ON (Transmission on)
The appropriate Start/Stop/Continue message will be
transmitted when the MRS-1266 stops or begins running
(default setting).
● OFF (Transmission off)
Start/Stop/Continue messages will not be transmitted.
Specifying transmission of
Program Change messages
You can specify whether Program Change messages will be
transmitted. Program Change are MIDI messages that signal
changes such as a switch in synthesizer sound number.
Refer to steps 1 - 4 of “Basic procedure” to bring up the
indication “PRG CHG” on the display. Then turn the dial to
select one of the following settings.
● ON (Transmission on)
When a drum kit/bass program is switched at the MRS-
1266, a Program Change message for the respective channel
is sent out. (default setting).
● OFF (Transmission off)
Program Change messages will not be transmitted.
H INT
Reception of Program Change messages is always enabled.
SPP SPP
ON
ON
COMMAND COMMAND
ON
ON
PRG CHG PRG CHG
ON
ON