beautypg.com

Listening to the demo song, Prj sel prj sel runaway runaway, Demo song protect status – Zoom MRS-1266 User Manual

Page 19: Turning on the power, Selecting the demo song

background image

Listening to the Demo Song

ZOOM MRS-1266

19

Demo song protect status

The demo song on the hard disk is set to protected status,

which means that level mixing and other settings can be

changed while you play the song, but the changes cannot be

stored on the disk. If you wish to retain changes you have

made, disable the protect status (

→ p. 141).

Turning on the power

1.

Make sure that the AC adapter, instrument, and

audio system (or headphones) are correctly

connected to the MRS-1266. (For information on

connections, refer to page 15.)

2.

Press the [POWER] switch on the rear panel.

Power to the MRS-1266 comes on, the unit performs a self-

test, and switch settings are read. Wait until the following

indication appears on the display.

This screen is called the "main screen".

3.

Turn on the audio system connected to the

MASTER OUTPUT jacks.

H

INT

When a synthesizer or other electronic instrument is con-

nected to the MRS-1266, turn power on in the order synthe-

sizer→ MRS-1266→ audio system. Turn power off in the re-
verse order.

Selecting the demo song

On the MRS-1266, song data are managed in units called

"projects". A project encompasses recorded audio data,

rhythm patterns and rhythm songs of the rhythm section,

internal effect patches (effect programs), and other

information. When you load a project, the complete state in

which that song was saved will be reproduced.

To load the demo song project from the hard disk, proceed

as follows.

1.

Press the [PROJECT] key.

The indication "PROJECT SELECT" appears on the display.

This is the screen for selecting a project.

2.

Press the [ENTER] key.

Projects stored on the hard disk are shown in the lower part

of the display.

3.

Turn the dial to select the demo song.

Project numbers 000 and 001 are the demo songs.

4.

Press the [ENTER] key.

The selected project is loaded. While the hard disk is being

accessed, the [HDD] indicator lights up and the indication

"LOADING" appears on the display. When the display

changes, the demo song has been loaded.

PRJ 000

PRJ 000
RunAway

RunAway

001- 1

001- 1

0 0 0 0

PRJ SEL

PRJ SEL
RunAway

RunAway

0

0

Project name

Project number

Listening to the Demo Song

When shipped from the factory, the internal hard disk of the MRS-1266 contains a demo song. To listen to the demo, proceed as

follows.