ZyXEL Communications P-335WT - Manual (Page 462)

P-335 Series User’s Guide
462 Appendix F
The filter types and their default settings are as follows.
Table 158 NetBIOS Filter Default Settings
NAME DESCRIPTION EXAMPLE
Between LAN
and WAN This field displays whether NetBIOS packets are blocked or forwarded
between the LAN and the WAN.
Block
IPSec
Packets This field displays whether NetBIOS packets sent through a VPN
connection are blocked or forwarded.
Forward
Trigger
dial This field displays whether NetBIOS packets are allowed to initiate
calls. Disabled means that NetBIOS packets are blocked from initiating
calls.
Disabled
NetBIOS Filter Configuration
Syntax:sys filter netbios config
where
= Identify which NetBIOS filter (numbered 0-3) to configure.
0 = Between LAN and WAN
3 = IPSec packet pass through
4 = Trigger Dial
= For type 0 and 1, use on to enable the filter and block NetBIOS packets.
Use off to disable the filter and forward NetBIOS packets.
For type 3, use on to block NetBIOS packets from being sent through a VPN
connection. Use off to allow NetBIOS packets to be sent through a VPN
connection.
For type 4, use on to allow NetBIOS packets to initiate dial backup calls.
Use off to block NetBIOS packets from initiating dial backup calls.
Example commands
sys filter netbios
config 0 on This command blocks LAN to WAN and WAN to LAN NetBIOS packets.
sys filter netbios
config 3 on This command blocks IPSec NetBIOS packets.
sys filter netbios
config 4 off This command stops NetBIOS commands from initiating calls.