ZyXEL Communications P-335WT - Manual (Page 296)

P-335 Series User’s Guide
296 Chapter 25 Menu 3 LAN Setup
Figure 148 Menu 3.5 Wireless LAN Setup
Menu 3.5 - Wireless LAN Setup
ESSID= Wireless
Hide ESSID= No
Channel ID= CH06 2437MHz
RTS Threshold= 2432
Frag. Threshold= 2432
WEP Encryption= Disable
Default Key= N/A
Key1= N/A
Key2= N/A
Key3= N/A
Key4= N/A
Authen. Method= N/A
Edit MAC Address Filter= No
Edit Roaming Configuration= No
Preamble= Long
802.11 Mode= Mixed
Press ENTER to Confirm or ESC to Cancel:
The following table describes the fields in this menu.
Table 102 Menu 3.5 Wireless LAN Setup
FIELD DESCRIPTION
ESSID The ESSID (Extended Service Set IDentity) identifies the AP to which the wireless
stations associate. Wireless stations associating to the AP must have the same
ESSID. Enter a descriptive name of up to 32 printable 7-bit ASCII characters.
Hide ESSID Press [SPACE BAR] and select Yes to hide the ESSID in the outgoing data frame so
an intruder cannot obtain the ESSID through passive scanning.
Channel ID Press [SPACE BAR] to select a channel. This allows you to set the operating
frequency/channel depending on your particular region.
RTS Threshold Setting this attribute to zero turns on the RTS/CTS handshake. Enter a value
between 0 and 2432.
Fragment
Threshold This is the maximum data fragment size that can be sent. Enter a value between 256
and 2432.
WEP Select Disable to allow wireless stations to communicate with the access points
without any data encryption.
Select 64-bit WEP or 128-bit WEP to enable data encryption.
Default Key Enter the key number (1 to 4) in this field. Only one key can be enabled at any one
time. This key must be the same on the Prestige and the wireless stations to
communicate.