5 monitor screen – ZyXEL Communications P-335WT User Manual
Page 262
P-335 Series User’s Guide
262
Chapter 20 Media Bandwidth Management
20.5 Monitor Screen
Select the Monitor tab in BW MGMT to view the bandwidth usage of the LAN, WAN and
WLAN configured bandwidth rules. This is also shown as bandwidth usage over the
bandwidth budget for each rule. The gray section of the bar represents the percentage of
unused bandwidth and the orange color represents the percentage of bandwidth in use.
Use All Managed
Bandwidth
Select this option to allow a rule to borrow unused bandwidth on the interface.
Bandwidth borrowing is governed by the priority of the rules. That is, a rule with
the highest priority is the first to borrow bandwidth. Do not select this if you want
to leave bandwidth available for other traffic types or if you want to restrict the
amount of bandwidth that can be used for the traffic that matches this rule.
Service
Select a service for your rule or you can define your own.
Destination Address Enter the destination IP address in dotted decimal notation.
Destination Subnet
Netmask
Enter the destination subnet mask. This field is N/A if you do not specify a
Destination Address. Refer to the appendices for more information on IP
subnetting.
Destination Port
Enter the port number of the destination. See
services and port numbers.
Source Address
Enter the source IP address in dotted decimal notation.
Source Subnet
Netmask
Enter the destination subnet mask. This field is N/A if you do not specify a
Source Address. Refer to the appendices for more information on IP subnetting.
Source Port
Enter the port number of the source. See for some common services and port
numbers.
Protocol
Enter the protocol (service type) number, for example: 1 for ICMP, 6 for TCP or
17 for UDP.
Apply
Click Apply to save your customized settings and exit this screen.
Reset
Click Reset to begin configuring this screen afresh.
Delete
Click Delete to remove a rule configuration.
Table 86 Bandwidth Management Edit
LABEL
DESCRIPTION