ZyXEL Communications P-335WT - Manual (Page 390)

P-335 Series User’s Guide
390 Chapter 37 Remote Management
Figure 232
Menu 24.11 - Remote Management Control
TELNET Server: Port = 23 Access = ALL
Secure Client IP = 0.0.0.0
FTP Server: Port = 21 Access = ALL
Secure Client IP = 0.0.0.0
Web Server: Port = 80 Access = ALL
Secure Client IP = 0.0.0.0
SNMP Service: Port = 161 Access = LAN only
Secure Client IP = 0.0.0.0
DNS Service: Port = 53 Access = LAN only
Secure Client IP = 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
Menu 24.11 – Remote Management Control
The following table describes the fields in this screen.
Table 138 Menu 24.11 – Remote Management Control
FIELD DESCRIPTION
Telnet Server
FTP Server
Web Server
SNMP Service
DNS Service Each of these read-only labels denotes a service or protocol.
Port This field shows the port number for the service or protocol. You may change the
port number if needed, but you must use the same port number to access the
Prestige.
Access Select the access interface (if any) by pressing [SPACE BAR], then [ENTER] to
choose from: LAN only, WAN only, ALL or Disable.
Secure Client IP The default 0.0.0.0 allows any client to use this service or protocol to access the
Prestige. Enter an IP address to restrict access to a client with a matching IP
address.
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.
37.1.1 Remote Management Limitations
Remote management over LAN or WAN will not work when:
A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or Web
service.
You have disabled that service in menu 24.11.
The IP address in the Secure Client IP field (menu 24.11) does not match the client IP
address. If it does not match, the Prestige will disconnect the session immediately.
1 There is an SMT console session running.