Nortel Networks 6.1 - Manual (Page 230)

230 / Using System features
Compact ICS 6.1 System Coordinator Guide P0603544 02
1. Press
²¥¥ЫЯЯЬЭЭ.
2. Press
ЫЬЯЭЯ (the default System Coordinator password).
3. Press ≠ at Terminals&Sets.
4. Enter the internal number of the telephone you want to program and
press ≠. The display shows Capabilities.
5. Press ≠.
6. Press ‘ until the display shows Hotline.
7. Press CHANGE to select the type of call the hotline makes: None,
Intrnl, or Extrnl.
Internal assigns an internal number.
External assigns an external number. If you select an external number, you
can select the line on which the call is made:
• the prime line
• an external line
• a line in a line pool, and a line pool access code
For this type of line, you must specify the line pool access code.
• a line selected by the routing table
For this type of line, the number dialed is treated as a destination code
and is routed according to the routing tables.
A telephone prime line, line pool access codes, and access to a line pool
can be programmed by your installer or customer service representative.
Control telephone
The control telephone allows you to place the telephones and external lines
for which it has responsibility into and out of service schedules. See
‘‘Using alternate or scheduled services’’ on page 219.
SM Supervisor
A telephone designated as an SM Supervisor allows you to
monitor Hunt group calls without or without a conference tone