Nortel Networks 6.1 - Manual (Page 174)

174 / Programming Hunt Groups
Compact ICS 6.1 System Coordinator Guide P0603544 02
5. Press MOVE to move an existing member to another place within the
Hunt Group. The display shows the member number followed by an
arrow.
6. Enter the new position number for the extension.
7. Press
¨ to exit or ‘ to continue programming.
Assigning or unassigning lines to a group
You can assign one or several lines to a hunt group.
Hunt group line notes:
• Configure the prime set for a Hunt Group line to None to avoid delayed
ring transfer of external Hunt Group calls to the prime set before the
Hunt Group can receive the call.
• A line can be assigned to only one group.
• Do not assign any hunt group lines to individual telephones. If any of
the telephones that are part of the hunt group have the line assigned,
remove the line from the telephone before assigning it to the hunt
group.
1. At Hunt groups, press ≠. The display shows Show group.
2. Enter the Hunt Group number you want to program (1-6) or press
‘
to scroll through the groups.
3. Press ≠. The display shows Member DNs:.
4. Press ‘. The display shows Line assignment.
5. Press ≠. The display shows Show line:.
6. Enter the line number you want to program and press SCAN to go to the
first line assigned to this group, or press LIST to go to the first line in
the system.
7. Press CHANGE to program the line as Unassigned or Assigned.
*HGnn* means the line is assigned to another Hunt Group.
8. Press
¨ to exit or ‘ to continue programming.