Nortel Networks 6.1 - Manual (Page 228)

228 / Using System features
Compact ICS 6.1 System Coordinator Guide P0603544 02
Using special telephones
Direct-dial
You can reach the direct-dial telephone by dialing a single digit. The
direct-dial telephone is usually in a central location, such as a attendant's
desk. It is usually the prime telephone or the central answering position
(CAP).
The direct-dial telephone can send up to 30 messages and can invoke
Services to activate the extra-dial telephone.
You cannot forward calls to a direct-dial telephone that is outside your
Norstar system. See ‘‘Making changes to Call Forward No Answer’’ on
page 37.
Note: ISDN terminals cannot use the Direct-Dial digit to reach a Direct-
Dial set.
Changing the direct-dial telephone assignments
Your installer or customer service representative sets up the direct-dial
telephone.
You can change which direct-dial telephone a telephone is assigned to, or
assign it no direct-dial telephone.
You need the programming template found at the front of this guide. See
‘‘Getting started with Norstar’’ on page 15 for more information.
1. Press
²¥¥ЫЯЯЬЭЭ.
2. Press
ЫЬЯЭЯ (the default System Coordinator password).
3. Press ≠ at Terminals&Sets.
4. Enter the internal number of the telephone you want to program and
press ≠. The display shows Capabilities.
5. Press ≠.
6. Press ‘ until the display shows D-Dial.
7. Press CHANGE to select either Set1 or None.