Panasonic MN103001G/F01K - Manual (Page 206)

Interrupt Controller
9-18
Group 10 interrupt control register
Register symbol: G10ICR
Address: x'34000128
Purpose: This register is used to enable group 10 interrupts, and to confirm interrupt requests and detection.
Bit No. 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Bit - G10 G10 G10 - - SC3T SC3R - - SC3T SC3R - - SC3T SC3R
name LV2 LV1 LV0 IE IE IR IR ID ID
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Access R R/W R/W R/W R R R/W R/W R R R/W R/W R R R/W R/W
Bit No. Bit name Description
0 SC3RID Serial 3 reception interrupt detection flag
0: No interrupt detected 1: Interrupt detected
1 SC3TID Serial 3 transmission interrupt detection flag
0: No interrupt detected 1: Interrupt detected
3 and 2 — "0" is returned when these bits are read.
4 SC3RIR Serial 3 reception interrupt request flag
0: No interrupt request 1: Interrupt request
5 SC3TIR Serial 3 transmission interrupt request flag
0: No interrupt request 1: Interrupt request
7 and 6 — "0" is returned when these bits are read.
8 SC3RIE Serial 3 reception interrupt enable flag
0: Disabled 1: Enabled
9 SC3TIE Serial 3 transmission interrupt enable flag
0: Disabled 1: Enabled
11 and 10 — "0" is returned when these bits are read.
12 G10LV0 Group 10 interrupt priority level register (LSB)
13 G10LV1 Group 10 interrupt priority level register
14 G10LV2 Group 10 interrupt priority level register (MSB)
Set a level from 6 to 0.
15 — "0" is returned when this bit is read.