Printronix P5000LJ Series - Manual (Page 67)

Connecting To The Network
67
Configuring NIC
Connecting To The Network
To attach the NIC to a network, plug the network cable into the NIC connector
(see Figure 10).
Watch the LEDs in the rear of the printer as they cycle through the power on
self-test. When the test is complete, the STAT led will flash.
Figure 10. Physical Setup
Configuration Setup
There are two parts to a NIC setup:
1. Configuring the NIC so it can be seen on the network. This involves
network related settings (e.g., an IP address within TCP/IP environments)
configured through the built-in command shell, npsh, or from the control
panel.
2. Configuring a host with a new printer so it knows how to send data to the
NIC. Just being able to see the printer on the network does not mean you
can automatically print to it. A host has to be told where to send the data.
Network Connector
A
A