Printronix P5000LJ Series - Manual (Page 251)

Set Commands
251
set snmp
To add a user named snmp with root privileges, please follow the steps
below:
1. Login to the NIC as a root user.
2. Add a user named snmp .
set user add snmp
3. Set the user type to root .
set user type snmp root
4. Set the password for the snmp user.
set user passwd snmp snmppassword
5. Save the changes.
save
The user snmp is now created and snmppassword is the only community
string which will allow write access.
set snmp manager index ipaddress trap-community
The Print Server continuously generates traps, but unless the trap table is
filled in, no SNMP manager will receive this information. To set the Print
Server to send traps to a particular SNMP manager, use this command to
add an SNMP manager to the trap table.
index is the index number of the trap table. ipaddress is the IP
address of the SNMP manager receiving traps. trap-community is the
community string sent along with the trap information.
set sysinfo name newname
set sysinfo name salesprinter
Set a descriptive name defined by newname for NIC identification
purposes. This is not used in the operation of the print server in any way.
set sysinfo location description
set sysinfo location salesdept
Set the physical location of the NIC. This is for identification purposes and
is not used in the operation of the print server in any way.
set sysinfo contact contactname
set sysinfo contact Paul_Harris
Set a person or department to contact in case of print server trouble.
set sysinfo loginfo [-]sys | [-]tcp | [-]ipx | [-]spx
set sysinfo loginfo -sys ipx
Set the NIC debugging information type. Usually this information includes
unexpected errors or exceptions from the print server divided into these
groups:
sys General system messages.
tcp TCP stack messages.
ipx IPX stack messages.
spx SPX stack messages.