Printronix P5000LJ Series - Manual (Page 256)

256
Chapter 13 Complete Command List
debug nest sap
Determine whether the NIC is seeing any Novell network activity.
debug netbios
List NetBIOS (i.e., Windows 95 and WfW) statistics.
debug nif
List network interface statistics.
debug novell
List file and print servers.
debug tcp
List TCP stack statistics.
Miscellaneous Commands
These commands do not fall under any specific section of the command shell,
but they are used quite frequently.
save [default]
Save the current settings to flash memory so they are available after
power cycles. Sysinfo, destination, model, logpath, variable, user, and I/O
port settings will be saved. If
default is specified as well, factory
settings will be saved, overwriting any new settings you have configured.
reset
Perform a warm boot or hardware reset simulating a power-on reset.
Restores current settings to those stored in flash memory since the flash
memory settings will be read and loaded into memory upon bootup.
load [default]
Load the settings stored in flash memory and use them as the current or
working settings. If
default is specified as well, factory settings will be
loaded.
lpstat [ioport] [jobID]
lpstat prn
Display active and queued jobs and I/O port status for a given ioport or
jobID . Specifying one of these parameters will shorten the output
focusing on the particular I/O port or print job specified.
cancel jobID
cancel d1prn-10
Remove a job from an I/O port queue. Use lpstat to find a particular
job ID first.