Printronix P5000LJ Series - Manual (Page 50)

50
Chapter 3 Configuring The Printer
Factory Default Configuration Values
The factory default values are permanently stored in memory as a
configuration and cannot be modified or erased. The configuration values for
the Bi-Tronics parallel interface and NIC interface are displayed on the
following pages.
Bi-Tronics Parallel Interface
ACTIVE EMULATION PCL-II
PCL-II
Primary Char. set
ID 0
Symbol Set Roman-8 [8U]
Pitch 10.00
Density Data Processing
Second Char. set
ID 0
Symbol Set Roman-8 [8U]
Pitch 10.00
Density Data Processing
Page Length Rep. Inches/Page
Max. Line Width 13.2 inches
Face, CPI Delay Enable
Graphics Density 60 DPI
Perforation Skip Disable
Display Functns Disable
Line Terminator
LF After CR Disable
CR After LF Disable
CR after FF Disable
CR After VT Enable
PTX Linefeed Disable
LPI Adjust 6 LPI
Page L./Lines 66 Lines
Page L./Inches 11.0 Inches
Config. Print
Symbol Set Print
Reset Cmd CFG Ld
Power Up Config
LP PLUS
Printer Protocol
P-Series
Control Code 06 8.0 LPI
Control Code 08 Elongated
Define CR Code CR = CR
Auto LF Disable
Overstrike Enable
Define LF code LF = CR + LF
Select SFCC 1
EVFU Select Enable
Alt. Set 80-9F Control Code
Character Set
IBM PC
Primary Subset ASCII (USA)
Extended Subset Code Page 437
SFCC d command Even dot plot
CPI/LPI Select
Select CPI 10.0 CPI
Select LPI 6.0 LPI