Paradyne 9128-II - Manual (Page 66)

3. Configuration
3-32 April 2002 9128-A2-GB20-60
Configuring Service Level Verification Options
SLV options are selected from the System menu (see Table 3-4, Service Level
Verification Options ).
Main Menu
→
Configuration
→
System
→
Service Level Verification
Table 3-4. Service Level Verification Options (1 of 3)
SLV Sample Interval (secs)
Possible Settings: 10 – 3600
Default Setting: 60
Sets the inband communications interval between FrameSaver SLV devices. Inband
communications are used to pass frames that calculate latency, as well as transmission
success and other SLV information.
10 – 3600 – Sets the SLV Sample Interval (secs) in seconds.
SLV Synchronization Role
Available Settings: Tributary, Controller, None
Default Setting: Tributary
Determines the role the unit plays in maintaining synchronization of user history data
collection and storage between FrameSaver SLV and/or FLEX devices.
Tributary – Uses network timing received from incoming SLV communications and
provides network-based synchronization information to other devices in the network.
Controller – Uses its own internal time-of-day clock and provides synchronization
information to other devices in the network based upon its own clock.
NOTE: Only one device in the network should be configured as the SLV
synchronization controller.
None – Incoming timing information is ignored and no timing information is sent out. This
setting should only be used when network synchronization is not desirable, or when a
single unit connects multiple networks or network segments.
SLV Type
Available Settings: Standard, COS 1–COS 7
Default Setting:
If SLV Feature is enabled: Standard
If SLV Feature is disabled: COS 1
Determines the type of SLV measurements to which these other SLV options apply:
T SLV Timeout Error Event Threshold
T SLV Timeout Clearing Event Threshold
T SLV Round Trip Latency Error Threshold
T SLV Latency Clearing Event Threshold
T SLV Packet Size
Standard – The options selected apply to standard FrameSaver SLV measurements,
utlizing an EDLCI for FrameSaver-to-FrameSaver communication. This option is not
available if the SLV Feature is disabed.
COS 1–COS 7 – The options selected apply to this Class of Service. Different settings
may be saved for each Class of Service.