Paradyne 9128-II - Manual (Page 109)

3. Configuration
9128-A2-GB20-60 April 2002 3-75
Configuring the IP Path List
Select IP Path List (Static) from the Configuration Edit/Display menu to display or
change the list of static path IP addresses explicitly defined in the unit.
Main Menu
→
Configuration
→
IP Path List (Static)
The IP Path List (Static) screen appears, showing any existing static paths. Paths
discovered as SLV packets are received from other FrameSaver units are not
shown. To view the entire current IP Path List, use the IP Path Connection Status
screen. See
IP Path Connection Status in Chapter 5, Operation and Maintenance.
Procedure
To add a static path:
1. Select New. The following prompt appears:
Enter IP Address (press ESC to abort): ___.___.___.___ FWD: No
2. Enter the IP address of a static path and select a forwarding option of No or
Yes using the spacebar.
3. Press enter. Select Save.
Table 3-16. IP Path List
IP Address
Possible Settings: 000.000.000.001 – 126.255.255.255, 128.000.000.000 –
223.255.255.255
Default Setting: Initially blank; no default.
Specifies the address of a FrameSaver or other device at the other end of a path.
000.000.000.001 – 126.255.255.255, 128.000.000.000 – 223.255.255.255 – Specifies the
address of a device.
FWD
Possible Settings: No, Yes
Default Setting: No
Determines whether this path list item is sent to all other addresses in the list that
represent FrameSaver devices.
No – The IP address associated with this path list item is not distributed.
Yes – The IP address associated with this path list entry is distributed to devices in the list.