Paradyne 9128-II - Manual (Page 236)

5. Operation and Maintenance
5-80 April 2002 9128-A2-GB20-60
Turning Off the System Alarm Relay
For carrier-mounted FrameSaver units, an alarm system relay is provided by the
9000 Series Access Carrier. This relay activates a light or buzzer when an alarm
condition is detected in one of the FrameSaver units.
Once the alarm relay is connected, enabling the System Alarm Relay option
activates this feature (see
Table 3-5, General System Options, in Chapter 3,
Configuration).
Once activated, the relay is turned off in one of the following ways:
T The alarm condition that activated the relay no longer exists. The relay stays
on until all alarm conditions have been corrected.
T The System Alarm Relay option can be disabled.
Main Menu
→
Configuration
→
System
→
General
T System Alarm Relay Cut-Off can be selected.
Main Menu
→
Control
→
System Alarm Relay Cut-Off
See Alarm Relay Connector in the 9000 Series Access Carrier Installation
Instructions for information about connecting the alarm relay.