Paradyne 9128-II - Manual (Page 139)

3. Configuration
9128-A2-GB20-60 April 2002 3-105
Disconnect Time (Minutes)
Possible Settings: 1 – 60
Default Setting: 10
Determines the amount of lapsed time before disconnecting a user session in minutes.
Display Conditions – This option only appears when:
T Port Use is set to Terminal.
T Inactivity Timeout is set to Enable.
1 – 60 – Sets the number of minutes allowed before the modem disconnects.
IP Address
Possible Settings: 001.000.000.000 – 223.255.255.255, Clear
Default Setting: Clear (000.000.000.000)
Specifies a unique IP address for accessing the system via the modem port. This option is
only in effect when the modem port is configured as a network communication link.
Display Conditions – This option only appears when Port Use is set to Net Link.
001.000.000.000 – 223.255.255.255 – Shows the IP address for the modem port, which
you can view or edit.
Clear – Clears the IP address for the modem port and fills the address with zeros ( i.e.,
000.000.000.000 ). When the IP Address is all zeros, the modem port uses the Node IP
Address if one has been configured.
Subnet Mask
Possible Settings: 000.000.000.000 – 255.255.255.255, Clear
Default Setting: 000.000.000.000
Specifies the subnet mask needed to access the system. This option is only in effect when
the modem port is configured as a network communication link.
Display Conditions – This option only appears when Port Use is set to Net Link.
000.000.000.000 – 255.255.255.255 – Shows the subnet mask for the modem port, which
you can view or edit.
Clear – Clears the subnet mask for the COM port and fills the address with zeros. When
the node subnet mask is all zeros, the IP protocol creates a default subnet mask based
upon the class of the IP address: Class A: 255.000.000.000, Class B: 255.255.000.000, or
Class C: 255.255.255.000.
Link Protocol
Possible Settings: PPP, SLIP
Default Setting: PPP
Specifies the link-layer protocol to be used. This option is only in effect when the modem
port is configured as a network communication link.
Display Conditions – This option only appears when Port Use is set to Net Link.
PPP – Point-to-Point Protocol.
SLIP – Serial-Line Internet Protocol.
Table 3-25. Modem Port Options (3 of 4)