Paradyne 9128-II User Manual
Page 272
6. Troubleshooting
6-36
April
2002
9128-A2-GB20-60
Table 6-5.
Ping Options (1 of 3)
Target IP Address
Possible Settings: 000.000.000.001–126.000.000.000,
128.000.000.000–223.255.255.255
Default Setting: 000.000.000.000
Specifies the IP address to which a ping will be sent.
000.000.000.001–126.000.000.000, 128.000.000.000–223.255.255.255 – Specifies the
IP address.
Destination Interface
Possible Settings: Use_Internal_Route, Port-
n
, Net1-FR1
Default Setting: Use_Internal_Route
Specifies the routing method or destination interface for the ping.
Use_Internal_Route – When choosing which interface to send the ping, the unit first
consults its routing table. If the address or subnet does not appear in the routing table, the
ping will be sent to the Default IP Destination, if defined. (See
Port-
n
, Net1-FR1 – The ping is sent out the specified destination regardless of the
internal route configuration.
DLCI
Possible Settings: 16–1007
Default Setting: [Lowest assigned DLCI on the selected interface]
Specifies the DLCI to be used for the ping.
If the DLCI is configured on a Virtual Channel Connection (VCC), the VCI and VPI are
displayed next to the DLCI.
Display Conditions
– This setting does not appear when Destination Interface is set to
Use_Internal_Route.
16–1007 – Specifies the DLCI.
EDLCI
Possible Settings: 0
Default Setting: 0
Specifies the EDLCI to be used for the ping.
Display Conditions
– This setting does not appear when Destination Interface is set to
Use_Internal_Route, and then appears only if the specified DLCI is multiplexed.
0 – Specifies the EDLCI. The field cannot be modified.