Paradyne 9128-II - Manual (Page 21)

1. About the FrameSaver SLV
9128-A2-GB20-60 April 2002 1-7
T Dual Flash Memory. Allows software upgrades while the unit is up and
running. Two software loads can be stored and implemented at the user’s
discretion.
T DSX-1 Drop/Insert Port. Allows DTEs/PBXs that support the DS1 signal
format to share the T1 network with other high-speed equipment so that voice
traffic can share the same local access circuit as the frame relay data.
T Back-to-Back Operation. Allows two FrameSaver devices to be connected
via a leased-line network or simulation so a point-to-point configuration can be
implemented.
T Enhanced Ping Operation. FrameSaver devices can check connectivity and
roundtrip response time to any remote device in either direction, via the
FrameSaver internal management network or the data path.
T Payload Management. Any standard, non-management DLCI can be
designated as payload managed, providing management directly from a user
data PVC, and support for Telnet, ping, SNMP, and FTP.
Additional FrameSaver SLV 9128 Features
The following features are unique to FrameSaver SLV 9128 and 9128-II units:
T Multiple Data Ports. Provides two data ports instead of one, which have
standard connectors so no special-order cables are required.
T Carrier-Mounted Models. For customers with high-density requirements,
FrameSaver SLV 9128s and 9128-IIs can be ordered as multislot units, called
Network Access Modules (NAMs), for insertion in the 14-slot 9000 Series
Access Carrier.
Additional FrameSaver 9126-A2 and 9128-II Features
FrameSaver SLV 9126-A2 and 9128-II units provide a 10/100 BaseT Ethernet LAN
interface for management, with automatic sensing of the operation rate of 10Mb or
100Mb, conforming to ANSI/IEEE 802.3.