Paradyne 9128-II - Manual (Page 191)

5. Operation and Maintenance
9128-A2-GB20-60 April 2002 5-35
Status Identifies whether the physical
interfaces, LMIs, and DLCIs are all
enabled and active for this PVC
connection.
Active * T The PVC is currently active.
Inactive T The PVC is inactive because:
– Alarm conditions and network
and SLV communication status
indicate that data cannot be
successfully passed.
– The unit has disabled the
interface or frame relay link
due to internal operating
conventions.
– Activation of an alternate
virtual circuit is not warranted;
that is, no alarm condition on
the primary destination link
has been detected.
Disabled T The PVC cannot be activated and
is essentially disabled as a result
of how the unit was configured.
Possible causes:
– The physical interface at one
or both ends of the PVC is/are
disabled.
– The frame relay link on one or
both ends of the PVC is/are
disabled.
Invalid T Some portion of the PVC
connection is not fully configured.
* For the circuit to be active, both Source and Destination Statuses must be Active.
Table 5-11. PVC Connection Status (2 of 2)
Field Status What It Indicates