Paradyne 9128-II - Manual (Page 181)

5. Operation and Maintenance
9128-A2-GB20-60 April 2002 5-25
Secondary Clock Failed A failure of the secondary clock source configured for
the unit is detected and the internal clock is providing
the timing for the unit.
The clock source will not automatically switch from
internal until the primary clock source returns.
Send Pattern Active, DLCI nnnn ,
frame_relay_link 1,2
A Send Pattern test is currently active on the
specified DLCI on the specified frame relay link.
Send Pttn Active, [Interface] A Send Pattern test is active on the specified
interface using a selected test pattern.
This test cannot be activated on user data ports that
have Port Use set to Frame Relay.
SLV Latency Exceeded,
DLCI
nnnn , frame relay link 1, 2, 3
The measured latency of SLV communication
responses from the remote unit on this DLCI is
excessive, so the DLCI has been declared unsuitable
for normal multiplexed PVC operation (DLCI Type is
set to Multiplexed).
SLV Timeout, DLCI nnnn ,
frame relay link
1, 2, 3
An excessive number of SLV communication
responses from the remote FrameSaver SLV unit
have been missed on the specified multiplexed DLCI;
the DLCI is not suitable for user data.
When a hardware bypass capable device has been
detected at the other end of the PVC and this
condition occurs, only user data for EDLCI 0 will be
transmitted while this condition exists.
When an ISDN DBM is present, this message only
appears for individual and aggregate multilink frame
relay links, not constituent links of a frame relay
multilink.
Suboptimal Link Rate,
frame relay link
2
(ISDN DBM only)
The specified frame relay multilink has failed to
achieve the configured Maximum Link Rate for the
link.
This message appears for multilink aggregate frame
relay links if LMI is down on any of its constituent
links.
Timeslot Discovery in Progress,
Network 1 Time slot discovery is currently taking place to
determine the time slots that will be used for frame
relay traffic on the network interface.
This message only appears when the Time Slot
Discovery option is enabled (
Main Menu
→
Configuration
→
Time Slot Assignment
→
Frame
Relay Network Assignments) and an LMI failure is
detected on the network interface’s frame relay link.
Table 5-7. Health and Status Messages (6 of 7)
Message What It Indicates
1
nnnn indicates a DLCI number of 16 through 1007.
2
frame relay link is one of the following:
– Net1-FR1. The frame relay link specified for the network interface, Network 1.
– Port-
n . The frame relay link associated with the user data port.
– ISDN Link Name on a non-network ISDN DBM interface.
3
Does not apply to a TS Management Link DLCI.