Paradyne 9128-II - Manual (Page 127)

3. Configuration
9128-A2-GB20-60 April 2002 3-93
Enterprise Specific Traps
Possible Settings: Enable, Disable
Default Setting: Enable
Determines whether trap messages for enterpriseSpecific events are sent to the currently
configured trap manager(s).
Enable – Sends trap messages for enterpriseSpecific events.
Disable – Does not send trap messages for enterpriseSpecific events.
Link Traps
Possible Settings: Disable, Up, Down, Both
Default Setting: Both
Determines whether SNMP linkDown or linkUp traps are sent to the currently configured
trap manager(s). A linkDown trap indicates that the unit recognizes a failure in one of the
interfaces. A linkUp trap indicates that the unit recognizes that one of its interfaces is
active.
Use the Link Traps Interface and the DLCI Traps on Interfaces configuration options to
specify which interface will monitor linkUp and linkDown traps messages.
Disable – Does not send linkDown or linkUp trap messages.
Up – Sends trap messages for linkUp events only.
Down – Sends trap messages for linkDown events only.
Both – Sends trap messages for linkUp and linkDown events.
Link Traps Interfaces
Possible Settings: Network, DSX-1, T1s, Ports, DBM, All
Default Setting: All
Specifies which interfaces will generate linkUp, linkDown, and enterpriseSpecific trap
messages. These traps are not supported on the COM port or Modem port.
Network – Generates these trap messages on the network interface only.
DSX-1 – For applicable T1 FrameSaver units, generates these trap messages on the
DSX-1 interface only.
T1s – For applicable T1 FrameSaver units, generates these trap messages for linkUp,
linkDown, and enterpriseSpecific events on both the T1 network and DSX-1 interfaces.
Ports – Generates these trap messages for linkUp, linkDown, and enterpriseSpecific
events on a user data port only.
DBM – For units with an ISDN DBM installed, generates these trap messages for linkUp,
linkDown, and enterpriseSpecific events on the DBM only.
All – Generates these trap messages for linkUp and enterpriseSpecific events on all
interfaces, except for the COM port or modem port, that are applicable to the FrameSaver
model.
Table 3-22. SNMP Traps and Trap Dial-Out Options (3 of 6)