Paradyne 9128-II - Manual (Page 43)

3. Configuration
9128-A2-GB20-60 April 2002 3-9
Setting Up So the Router Can Receive RIP
Using the system’s standard Routing Information Protocol (RIP) feature, routing
information is passed to the router over the management PVC, so the router can
learn routes to FrameSaver SLV and FLEX devices. Node IP information should be
set up (see
Configuring Node IP Information on page 3-77).
Procedure
1. Configure the router to receive RIP.
For example, if using a Cisco router, configure config-t , router RIP , int
serial x , IP RIP Receive version 1 , then ctl-z WR .
2. Create a Standard DLCI for the user data port.
Configuration
→
Data Ports
→
DLCI Records
3. Create a Management PVC using the user data port DLCI just configured.
Configuration
→
Management and Communication
→
Management PVCs
4. Set Primary Link RIP to Standard_Out, and Save the configuration.
Refer to Table 3-14, DLCI Record Options , and Table 3-18, Management PVC
Options , for configuration information.