Paradyne 9128-II User Manual
Page 115
3. Configuration
9128-A2-GB20-60
April 2002
3-81
Payload Managed
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies whether the PVC is payload managed.
Display Conditions –
This is a read-only field set to Enabled if the PVC is IP Enabled.
Enable – The network PVC created will be monitored for the presence of IP frames
containing the IP address specified in the Intf IP Address field. When such a frame is
identified, it is extracted from the data stream and sent to the management stack.
Disable – A normal management PVC is created using the specified DLCI or EDLCI.
Intf
IP Address
Possible Settings: Node-IP-Address, Special
(
nnn
.
nnn
.
nnn
.
nnn
)
Default Setting: Node-IP-Address
Specifies the IP address needed to access the unit via this management PVC, providing
connectivity to an external IP network through the frame relay network.
Node-IP-Address – Uses the IP address contained in the Node IP Address (see
Special (001.000.000.000 – 223.255.255.255) – Allows you to display/edit an IP address
for the unit’s management PVC when the IP address for this interface is different from the
node’s IP address.
Intf
Subnet Mask
Possible Settings: Node-Subnet-Mask, Calculate, Special (
nnn
.
nnn
.
nnn
.
nnn
)
Default Setting: Node-Subnet-Mask
Specifies the subnet mask needed to access the unit when the management PVC is
providing connectivity to an external IP network (through frame relay) that requires a
specific subnet mask for the interface.
Node-Subnet-Mask – Uses the
Interface
IP Subnet contained in the Node-Subnet Mask
configuration option (see
Calculate – Calculates the subnet mask created by the IP protocol based on the class
of the IP address (Class A: 255.000.000.000, Class B: 255.255.000.000, or
Class C: 255.255.255.000). Cannot be displayed or edited.
Special (000.000.000.000 – 255.255.255.255) – Allows you to edit/display the subnet
mask for the management PVC when the subnet mask is different for this interface. A text
field displays where you can enter the subnet mask for this unit’s management PVC.
Set DE
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies whether frames (packets) sent on a management PVC have the Discard Eligible
(DE) bit set. This bit is used by the network to prioritize which frames to discard first during
periods of network congestion. This allows management traffic to be viewed as lower
priority than customer data.
Enable – Sets the DE bit to one on all frames sent on the management PVC.
Disable – Sets the DE bit to zero on all frames sent on the management PVC. This is the
recommended setting, particularly for NSPs providing a managed network service.
Table 3-18. Management PVC Options (2 of 6)