SMC Networks SMC TigerStack 1000 SMC8748M - Manual (Page 306)

C
OMMAND
L
INE
I
NTERFACE
4-34
Example
This example shows how to renumber all units.
User Access Commands
The basic commands required for management access are listed in this
section. This switch also includes other options for password checking via
the console or a Telnet connection (page 4-13), user authentication via a
remote authentication server (page 4-91), and host access authentication
for specific ports (page 4-104).
username
This command adds named users, requires authentication at login,
specifies or changes a user's password (or specify that no password is
required), or specifies or changes a user's access level. Use the no form to
remove a user name.
Syntax
username name {access-level level | no password |
password {0 | 7} password}
no username name
• name - The name of the user.
(Maximum length: 8 characters, case sensitive. Maximum users: 16)
• access-level level - Specifies the user level.
The device has two predefined privilege levels:
0: Normal Exec, 15: Privileged Exec.
• nopassword - No password is required for this user to log in.
• {0 | 7} - 0 means plain password, 7 means encrypted password.
Console#switch all renumber
Console#
Table 4-9 User Access Commands
Command Function Mode Page
username Establishes a user name-based authentication
system at login GC 4-34
enable password Sets a password to control access to the
Privileged Exec level GC 4-36