Editing vlan groups, Vlan database, Editing vlan groups -236 – SMC Networks SMC TigerStack 1000 SMC8748M User Manual
Page 508: Vlan database -236, Table 4-57 editing vlan groups -236, 236 editing vlan groups

C
OMMAND
L
INE
I
NTERFACE
4-236
Editing VLAN Groups
vlan database
This command enters VLAN database mode. All commands in this mode
will take effect immediately.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Use the VLAN database command mode to add, change, and delete
VLANs. After finishing configuration changes, you can display the
VLAN settings by entering the show vlan command.
• Use the interface vlan command mode to define the port
membership mode and add or remove ports from a VLAN. The
results of these commands are written to the running-configuration
file, and you can display this file by entering the show
running-config command.
Configuring Private
VLANs
Configures private VLANs, including uplink and
downlink ports
Configuring Protocol
VLANs
Configures protocol-based VLANs based on
frame type and protocol
Table 4-57 Editing VLAN Groups
Command
Function
Mode Page
vlan database
Enters VLAN database mode to add,
change, and delete VLANs
GC
vlan Configures
a
VLAN, including VID,
name and state
VC
Table 4-56 VLAN Commands (Continued)
Command Groups
Function
Page