SMC Networks SMC TigerStack 1000 SMC8748M - Manual (Page 418)

C
OMMAND
L
INE
I
NTERFACE
4-146
SNMP Commands
Controls access to this switch from management stations using the Simple
Network Management Protocol (SNMP), as well as the error types sent to
trap managers.
SNMP Version 3 also provides security features that cover message
integrity, authentication, and encryption; as well as controlling user access
to specific areas of the MIB tree. To use these commands, first configure
an SNMP engine ID, specify read and write access views for the MIB tree,
configure SNMP user groups with the required security model (i.e., SNMP
v1, v2c or v3) and security level (i.e., authentication and privacy), and then
assign SNMP users to these groups, along with their specific
authentication and privacy passwords
Table 4-39 SNMP Commands
Command Function Mode Page
snmp-server Enables the SNMP agent. GC 4-147
show snmp Displays the status of SNMP
communications NE,
PE 4-148
snmp-server
community Sets up the community access string to
permit access to SNMP commands GC 4-149
snmp-server contact Sets the system contact string GC 4-150
snmp-server location Sets the system location string GC 4-150
snmp-server host Specifies the recipient of an SNMP
notification operation GC 4-151
snmp-server enable
traps Enables the device to send SNMP traps
(i.e., SNMP notifications) GC 4-153
snmp-server
engine-id Sets the SNMP engine ID GC 4-154
show snmp engine-id Shows the SNMP engine ID PE 4-155
snmp-server view Adds an SNMP view GC 4-156
show snmp view Shows the SNMP views PE 4-157