SMC Networks SMC TigerStack 1000 SMC8748M - Manual (Page 463)

R
ATE
L
IMIT
C
OMMANDS
4-191
rate-limit
This command defines the rate limit for a specific interface. Use this
command without specifying a rate to restore the default rate. Use the no
form to restore the default status of disabled.
Syntax
rate-limit {input | output} [rate]
no rate-limit {input | output}
• input – Input rate
• output – Output rate
• rate – Maximum value in Mbps. (Range: 1 to 1000 Mbps)
Default Setting
1000 Mbps
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input 600
Console(config-if)#