Map access-list mac, Map access-list mac -142, Table 4-37 egress queue priority mapping -142 – SMC Networks SMC TigerStack 1000 SMC8748M User Manual
Page 414
C
OMMAND
L
INE
I
NTERFACE
4-142
Example
Related Commands
map access-list mac
This command sets the output queue for packets matching an ACL rule.
The specified CoS value is only used to map the matching packet to an
output queue; it is not written to the packet itself. Use the no form to
remove the CoS mapping.
Syntax
[no] map access-list mac acl_name cos cos-value
• acl_name – Name of the ACL. (Maximum length: 16 characters)
• cos-value – CoS value. (Range: 0-7)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
• You must configure an ACL mask before you can map CoS values to
the rule.
• A packet matching a rule within the specified ACL is mapped to one
of the output queues as shown below.
Console#show mac access-group
Interface ethernet 1/5
MAC access-list M5 out
Console#
Table 4-37 Egress Queue Priority Mapping
Priority
0
1
2
3
4
5
6
7
Queue
1
2
0
3
4
5
6
7