SMC Networks SMC TigerStack 1000 SMC8748M - Manual (Page 402)

C
OMMAND
L
INE
I
NTERFACE
4-130
Command Mode
Interface Configuration (Ethernet)
Command Usage
• You must configure an ACL mask before you can map CoS values to
the rule.
• A packet matching a rule within the specified ACL is mapped to one
of the output queues as shown in the following table. For information
on mapping the CoS values to output queues, see queue cos-map on
4-263.
Example
Related Commands
queue cos-map (4-263)
show map access-list ip (4-130)
show map access-list ip
This command shows the CoS value mapped to an IP ACL for the current
interface. (The CoS value determines the output queue for packets
matching an ACL rule.)
Syntax
show map access-list ip [interface]
interface
ethernet unit/port
• unit - Stack unit. (Range: 1-8)
• port - Port number. (Range: 1-24/48)
Table 4-35 Egress Queue Priority Mapping
Priority 0 1 2 3 4 5 6 7
Queue 1 2 0 3 4 5 6 7
Console(config)#interface ethernet 1/25
Console(config-if)#map access-list ip bill cos 0
Console(config-if)#