Access-list ip, Access-list ip -117 – SMC Networks SMC TigerStack 1000 SMC8748M User Manual
Page 389

A
CCESS
C
ONTROL
L
IST
C
OMMANDS
4-117
access-list ip
This command adds an IP access list and enters configuration mode for
standard or extended IP ACLs. Use the no form to remove the specified
ACL.
Syntax
[no] access-list ip {standard | extended} acl_name
• standard – Specifies an ACL that filters packets based on the
source IP address.
• extended – Specifies an ACL that filters packets based on the
source or destination IP address, and other more specific criteria.
• acl_name – Name of the ACL. (Maximum length: 16 characters)
access-list ip
mask-precedence
Changes to the IP Mask mode used to
configure access control masks
GC
mask
Sets a precedence mask for the ACL
rules
IP-Mask
show access-list ip
mask-precedence
Shows the ingress or egress rule masks
for IP ACLs
PE
ip access-group
Adds a port to an IP ACL
IC
show ip
access-group
Shows port assignments for IP ACLs
PE
map access-list ip
Sets the CoS value and corresponding
output queue for packets matching an
ACL rule
IC
show map
access-list ip
Shows CoS value mapped to an access
list for an interface
PE
match access-list ip Changes the 802.1p priority, IP
Precedence, or DSCP Priority of a
frame matching the defined rule (i.e.,
also called packet marking)
IC
show marking
Displays the current configuration for
packet marking
PE
Table 4-34 IP ACL Commands (Continued)
Command
Function
Mode
Page