Figure 3-46 acl mask configuration - ip -97 – SMC Networks SMC TigerStack 1000 SMC8748M User Manual
Page 153
A
CCESS
C
ONTROL
L
ISTS
3-97
specify a host address (not a subnet), or “IP” to specify a range of
addresses. (Options: Any, Host, IP; Default: Any)
•
Source/Destination Subnet Mask – Source or destination address
of rule must match this bitmask. (See the description for SubMask on
page 3-89.)
•
Protocol Mask – Check the protocol field.
•
Service Type Mask – Check the rule for the specified priority type.
(Options: Precedence, TOS, DSCP; Default: TOS)
•
Source/Destination Port Bit Mask – Protocol port of rule must
match this bitmask. (Range: 0-65535)
•
Control Code Bit Mask – Control flags of rule must match this
bitmask. (Range: 0-63)
Web – Configure the mask to match the required rules in the IP ingress or
egress ACLs. Set the mask to check for any source or destination address, a
specific host address, or an address range. Include other criteria to search
for in the rules, such as a protocol type or one of the service types. Or use
a bitmask to search for specific protocol port(s) or TCP control code(s).
Then click Add.
Figure 3-46 ACL Mask Configuration - IP