beautypg.com

Link aggregation commands, Link aggregation commands -192, Table 4-49 link aggregation commands -192 – SMC Networks SMC TigerStack 1000 SMC8748M User Manual

Page 464

background image

C

OMMAND

L

INE

I

NTERFACE

4-192

Link Aggregation Commands

Ports can be statically grouped into an aggregate link (i.e., trunk) to
increase the bandwidth of a network connection or to ensure fault
recovery. Or you can use the Link Aggregation Control Protocol (LACP)
to automatically negotiate a trunk link between this switch and another
network device. For static trunks, the switches have to comply with the
Cisco EtherChannel standard. For dynamic trunks, the switches have to
comply with LACP. This switch supports up to six trunks. For example, a
trunk consisting of two 1000 Mbps ports can support an aggregate
bandwidth of 4 Gbps when operating at full duplex.

Table 4-49 Link Aggregation Commands

Command

Function

Mode

Page

Manual Configuration Commands
interface port-channel Configures a trunk and

enters interface
configuration mode for the
trunk

GC

4-174

channel-group

Adds a port to a trunk

IC (Ethernet)

4-194

Dynamic Configuration Commands
lacp

Configures LACP for the
current interface

IC (Ethernet)

4-194

lacp system-priority

Configures a port's LACP
system priority

IC (Ethernet)

4-197

lacp admin-key

Configures a port's
administration key

IC (Ethernet)

4-198

lacp admin-key

Configures a port channel’s
administration key

IC (Port Channel)

4-199

lacp port-priority

Configures a port's LACP
port priority

IC (Ethernet)

4-200

Trunk Status Display Commands
show interfaces status
port-channel

Shows trunk information

NE, PE

4-183

show lacp

Shows LACP information

PE

4-201

This manual is related to the following products: