SMC Networks SMC TigerStack 1000 SMC8748M - Manual (Page 503)

S
PANNING
T
REE
C
OMMANDS
4-231
spanning-tree mst port-priority
This command configures the interface priority on a spanning instance in
the Multiple Spanning Tree. Use the no form to restore the default.
Syntax
spanning-tree mst instance_id port-priority priority
no spanning-tree mst instance_id port-priority
• instance_id - Instance identifier of the spanning tree.
(Range: 1-4094, no leading zeroes)
• priority - Priority for an interface. (Range: 0-240 in steps of 16)
Default Setting
128
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This command defines the priority for the use of an interface in the
multiple spanning-tree. If the path cost for all interfaces on a switch
are the same, the interface with the highest priority (that is, lowest
value) will be configured as an active link in the spanning tree.
• Where more than one interface is assigned the highest priority, the
interface with lowest numeric identifier will be enabled.
Example
Related Commands
spanning-tree mst cost (4 -229)
Console(config)#interface ethernet ethernet 1/5
Console(config-if)#spanning-tree mst 1 port-priority 0
Console(config-if)#