SMC Networks SMC TigerStack 1000 SMC8748M - Manual (Page 522)

C
OMMAND
L
INE
I
NTERFACE
4-250
3. Then map the protocol for each interface to the appropriate
VLAN using the protocol-vlan protocol-group command
(Interface Configuration mode).
protocol-vlan protocol-group (Configuring Groups)
This command creates a protocol group, adds specific protocols to a
group. Use the no form to remove a protocol group.
Syntax
protocol-vlan protocol-group group-id [{add | remove}
frame_type frame protocol-type protocol]
no protocol-vlan protocol-group group-id
• group-id - Group identifier of this protocol group.
(Range: 1-2147483647)
• frame 17 - Frame type used by this protocol. (Options: ethernet,
rfc_1042, llc_other)
• protocol - Protocol type. The only option for the llc_other frame
type is ipx_raw. The options for all other frames types include: ip,
arp, rarp.
Default Setting
No protocol groups are configured.
Command Mode
Global Configuration
Example
The following creates protocol group 1, and specifies Ethernet frames
with IP and ARP protocol types.
17. SNAP frame types are not supported by this switch due to hardware limitations.
Console(config)#protocol-vlan protocol-group 1 add frame_type
ethernet protocol-type ip
Console(config)#protocol-vlan protocol-group 1 add frame_type
ethernet protocol-type arp
Console(config)#