Spectra Precision ProMark 800 Reference Manual - Manual (Page 160)

148
Set Command Library
Command Format Syntax
$PASHS,ANP,REF,s1[,d2][*cc]
Parameters
Comments
• Specifying the antenna name allows the receiver to know
the antenna offset parameters using the predefined list. In
the receiver, the predefined parameters can be listed
using $PASHQ,ANP. New offset parameters can be added
using $PASHS,ANP,PCO.
• The predefined list complies with the IGS antenna source
table.
Example
Entering “MAG990596” as the name of the base antenna:
$PASHS,ANP,REF,MAG990596*3A
Relevant Query
Command
$PASHQ,ANP
$PASHQ,ANP,REF
See Also $PASHS,ANP,OWN
ANR: Antenna Reduction Mode
Function This command allows you to set the antenna reduction mode.
The default value is ON.
Command Format Syntax
$PASHS,ANR,s1[*cc]
Parameter Description Range Default
s1
User-defined antenna name (case-
sensitive). 31 characters
max.
UNKNOWN
d2
Antenna name preference:
• 0: s1 is ignored if a base
antenna name is decoded from
the incoming reference data.
• 1: s1 is always used regardless
of whether a base antenna
name is decoded from the
incoming reference data or not.
0, 1 0
*cc Optional checksum *00-*FF