Receiver is not tracking satellites – Spectra Precision ProMark 800 Reference Manual User Manual
Page 110

98
Troubleshooting
Receiver is Not Tracking Satellites
202 Medium Invalid link speed
You are trying to set a baud rate that is not appropriate. Find which 
baud rate should be used and try again.
203 Medium Invalid FEC mode
You are trying to set a FEC mode that is not appropriate. Check that 
you are asking for a valid one.
204 Medium
Too many config files 
(*.par)
The receiver is trying to use a configuration file but does not know 
which one to use. Make sure there’s only one file available and it is the 
one you want the receiver to use.
205 Medium
Invalid registration code => 
No registration code
No registration code entered for the receiver. Contact Technical Sup-
port.
206 Medium
Invalid registration code => 
Bad registration code
The receiver detects an incorrect registration code. Contact Technical 
Support.
207 Medium
Invalid Position => Position 
from $PASHS,POS
The receiver detects an incorrect position assigned to its location. Use 
$PASHS,POS to enter the right position. 
208 Medium GSM already in FTP mode
You are trying to assign a function to the modem while it’s already 
used in a network connection using the FTP protocol. See what you 
want the modem to do and then take the necessary steps to use it as 
desired.
209 Medium
ADL Radio Power is 
reduced
The receiver detects that the radiated power level set in the radio used 
was intentionally lowered. This is because the radio is powered from 
the internal battery, not from an external power source.
210 Medium
Radio Protocol not sup-
ported
You are trying to set a protocol that does not match the type of radio 
used. Choose a suitable protocol and try again.
213 Medium
Bad Base Position => In 
Rover mode, base position 
received
The receiver detects a bad base position received from the base. 
Check base position and correct it at the base.
214 Medium
Bad Base Position => In 
Base mode, base position 
sent
The receiver detects a bad base position assigned to the base. Check 
base position and correct it.
215 Medium GNSS in Boot mode
Contact Technical Support.
216 Medium ANP forbidden if HDB OFF
You are trying to enter a user-defined antenna while HDB is off. Set 
HDB to on and try again.
217 Medium RCP forbidden if HDB OFF
You are trying to enter a user-defined antenna while HDB is off. Set 
HDB to on and try again.
218 Medium Corrupted USB
A corrupted directory (“Found.*”) has been detected on the USB. The 
key can still be used out of this directory. Re-formatting should be envi-
sioned.
219 Medium USB directory overflow
One directory has more than 500 files. The USB key is unmounted 
automatically..
#
Rank
Alarm Label
Symptoms & Remedies
RTK Base
RTK Rover
PP Base
PP Rover
Relevant to
•
•
•
•
