Honeywell DCP552 Mark II - Manual (Page 81)

5-35
● Voltage, Open collector output (with setup data C22 set between 2 to 5)
Chapter 5. FUNCTIONS
Initialization of PID
control computation
Output deviation limiter
PID control computation
Setting: PID paramete P / l / d / rE (for CH2)
Setup data C24
Setting: variable parameter PA27 , PA96
Setting: variable parameter PA24
Upper and lower output limiter
Setting: PID parameter oL / oH (for CH2)
ON-OFF control computation
Setting: variable parameter PA26
(PID parameter oL , oH are valid when setup
data C22 is set to 3 or 5.)
During ON-OFF control
AT computation
Setting: variable parameter PA93 , PA94 , PA95
(Variable parametesr PA94 and PA95 are valid
when setup data C22 is set to 3 or 5, respectively.)
(AT not performed during CH2 O
2
sensor input) During AT executing
Setting: setup data C39 , C40
During overrange
Setting: setup data C38
In READY mode
In MANUAL mode
Preset MANUAL value
Proportional output cycle
during output 2
Setting: variable parameter PA25
Setup data C94
(not valid during ON-OFF control and AT execution or
when setup data
C22 is set to 2 or 4.)
Setting: setup data C41 , C42
Output voltage 2
adjustment
(For 6D output)
Setting: setup data
C96
Output 2
Voltage time proportional output
Proportional output when open collector is on
Manipulated variable during overrange
Manipulated variable in READY mode
MANUAL Manipulated variable
Manipulated variable (MV2)