Honeywell DCP552 Mark II - Manual (Page 176)

10-5
● Autotuning cannot be canceled with AT key
● PID parameter setting state cannot be invoked with PID key
● Event configuration setting state cannot be invoked with FUNC and PARA keys
● Setup data setting state cannot be invoked with SETUP key
● Fixed command control data setting state cannot be invoked with FUNC and PID keys
● Program setting state cannot be invoked with FUNC and PROG keys
● Program copy cannot be performed with ↑ and PROG keys
Cause Measure
Set to be except READY mode. Set READY mode to execute RESET operation (PROG +
RUN/HOLD keys).
Program selected in READY mode is unset. Select number ofa set program.
Fixed command control mode is on. Set fixed command control data ConSt to 0.
Mode other than READY Press DISP key to invoke normal display mode.
Program protected Set variable parameter
PA02
to 0, 2 or 4.
Set to key lock. Set variable parameter PA01 to 0.
Cause Measure
Normal display mode not on Press DISP key to invoke normal display mode.
Set to fixed command control mode. Set fixed command control data ConSt setting to 0.
Set to key lock. Set variable parameter PA01 to 0 or 1.
Cause Measure
Normal display mode not on Press DISP key to invoke normal display mode.
Mode other than READY Set READY mode to execute RESEToperation (PROG +
RUN/HOLD keys).
Set to key lock. Set variable parameter PA01 to 0 or 1.
Cause Measure
Normal display mode not on Press DISP key to invoke normal display mode.
Mode other than READY Set READY mode to execute RESEToperation (PROG +
RUN/HOLD keys).
Set to key lock. Set variable parameter
PA01
to 0.
Cause Measure
Normal display mode not on Press DISP key to invoke normal display mode.
Set to key lock. Set variable parameter PA01 to 0 or 1.
Cause Measure
Set to key lock. Set variable parameter PA01 between 0 to 2.
Chapter 10. TROUBLESHOOTING