Chapter 7. parameter setup, 1 parameter setup, 7 - 1 parameter setup – Honeywell DCP552 Mark II User Manual

Page 100: Selecting parameter settings groups

Chapter 7.

PARAMETER SETUP

7 - 1

Parameter Setup

Parameter settings can be changed when the

DCP552

is in the normal display mode.

When not in the normal display mode, press the

DISP key

to invoke it.

■

Selecting parameter settings groups

In the normal display mode, the keys listed in the table below can be used to select
settings groups and individual items in these groups.

Individual items in each settings group are listed below.
Variable parameter

PA01

Event configuration data

E01-t

PID parameters

P-1

in READY mode

Use

setting in the used PID group in modes other

than READY mode.

Setup data

C01

Constant value control data :

ConSt

when using

FUNC + PID key

when using the

PID key

in constant value

control mode

■

Progression of individual items in parameter settings

The item codes for individual (specific) items are shown on display panel 1, their
set values are shown on display panel 2 and their mnemonic codes are shown on
the message panel.
Individual items are displayed in the vertical-horizontal matrix shown on page 7-3,
with matrix sizes varying according to settings group. The ↑

key

, ↓

key

, ←

key

and →

key

are used to cycle through individual items.

The

PARA key

(valid for variable parameters and event configuration data),

PID

key

(valid for PID parameters and constant value control data) or the

SETUP key

(valid for setup data) allow you to search for displayable items in ascending order
of item number.

PARA key

Variable parameter

Constant value control data

Setup data

Constant value control

data (does not include

ConSt

)

PID parameter

Event configuration data

FUNC + PARA key

PID key
(In program run mode)

PID key
(In constant value

control mode)
SETUP key
(In READY mode)

FUNC + PID key
(In READY mode)