Honeywell DCP552 Mark II - Manual (Page 158)

8 - 2 Copying Programs
The DCP552 allows you to copy programs when it is in the READY program run mode. If not in this mode, press
the DISP key to invoke the normal display mode.
■ Program copy procedures
(1) Invoke the program run READY program run mode.
Set variable parameter PA01 to 0 or 1 and set variable parameter PA02 to 0.
(2) Press the PROG key and the ↑, ↓, ←, and → key keys in the normal
display mode to select the number of the program to be copied.
This is not possible when the program number is selected using external
switch inputs.
See “Section 6-3 Selecting Programs” (page 6-11) for details.
(3) Press the ↑ key and the PROG key to display “ COPY ” in display panel 1.
The number of the program to be copied starts to flash in display panel 2.
(4) Press the ↑, and ↓ keys and currently unset program numbers that can be
used as numbers for the program to be copied start to flash.
When there are no unset numbers, “-----” is displayed in display panel 2.
(5) Press the ENTER key to start program copy and display panel 2 stops
flashing. Programs in CH1 and CH2 are copied simultaneously. Repeat steps r
and t to copy more programs.
Repeat steps (4) and (5) to copy more programs.
(6) When a program has been copied, press the DISP key .
● Display
PROG SEG
PROFILE
Program
number
Segment
number
Pattern trend
Copy destination
program number
8-23
Chapter 8. PROGRAM SETUP