PLANET CS-1000 - Manual (Page 54)

Multi-Homing Security Gateway User’s Manual
settings for the WAN network group(s) will appear on the screen.
ÍÍ
Definitions :
Name : Name of the WAN group.
Member : Members of the group.
Configure : Configure the settings of WAN group. Click Modify to change the parameters of WAN group.
Click Remove to delete the selected group.
NOTE: In the WAN Group window, if one of the members has been added to the Policy, “In Use” message
will appear in the Configure column. You are not allowed to modify or remove the settings. Go to the Policy
window to remove the setting, and then you can configure.
Adding an WAN Group
Step 1. In the WAN Group window, click the New Entry button and the Add New Address Group
window will appear.
Step 2. In the Add New Address Group window the following fields will appear:
„ Name: enter the name of the new group.
„ Available address: List the names of all the members of the WAN network.
„ Selected address: List the names to assign to the new group.
„ Add members: Select the names to be added in the Available address list, and click the
Add>> button to add them to the Selected address list.
„ Remove members: Select the names to be removed in the Selected address list, and click
the < button to remove them from the Selected address list.
Step 3. Click
OK to add the new group or click Cancel to discard changes.
- 48 -