PLANET CS-1000 User Manual
Page 177
Multi-Homing Security Gateway User’s Manual
Step 2:
Configure the parameters.
Source Address:
Select the name of the DMZ network from the drop down list. The drop down
list will contain names of DMZ networks defined in DMZ section of the Address menu. To add a
new source address, please go to the DMZ section under the Address menu.
Destination Address:
Select the name of the WAN network from the drop down list. The drop
down list lists names of addresses defined in WAN section of the Address menu. To add a new
destination address, please go to WAN section of the Address menu.
Service:
Select a service from drop down list. The drop down list will contain services defined in
the Custom or Group section under the Service menu. These are services/application that are
allowed to pass from the DMZ network to the WAN network. Choose ANY for all services. To
add or modify these services, please go to the Service menu.
Schedule
: Select the item listed in the schedule to enable the policy to automatically execute
the function in a certain time and range.
Authentication User:
Select the item listed in the Authentication User to enable the policy to
automatically execute the function in a certain time and range.
Trunk:
Check to allow VPN traffic passing through.
Action:
Select Permit or Deny ALL from the drop down list to allow or reject the packets
travelling from the specified DMZ network to the WAN network.
Traffic Log:
Select Enable to enable flow monitoring.
Statistics:
Select Enable to enable flow statistics.
IDP:
Check to enable IDP feature.
- 171 -