PLANET CS-1000 - Manual (Page 25)

Multi-Homing Security Gateway User’s Manual
Dynamic Routing (RIPv2)
Enable Dynamic Routing (RIPv2), CS-1000 will advertise an IP address pool to the specific network so that
the address pool can be provided to the network. You can choose to enable LAN, WAN or DMZ interface to
allow RIP protocol supporting.
Routing information update timer: CS-1000 will send out the RIP protocol in a period of time to update the
routing table, the default timer is 30 seconds.
Routing information timeout: If CS-1000 does not receive the RIP protocol from the other router in a period
of time, it will cut off the routing automatically until it receives RIP protocol again. The default timer is 180
seconds.
To-Appliance Packet Logging
When the function is selected, the CS-1000 will record the packets that contain the IP address of CS-1000 in
source or destination, the records will display in Traffic Log for administrator to inquire about.
System Reboot
Once this function is enabled, the Multi-Homing Security Gateway will be rebooted.
Reboot Appliance: Click Reboot.
A confirmation pop-up box will appear. Follow the confirmation pop-up box, click OK to restart Multi-Homing
Security Gateway or click Cancel to discard changes.
- 19 -