PLANET CS-1000 - Manual (Page 42)

Multi-Homing Security Gateway User’s Manual
WAN No : WAN port 1 or 2.
Connect Mode : Display the current connection mode: PPPoE, Dynamic IP Address (Cable Modem User) or
Static IP Address.
IP Address: Display the current WAN IP Address.
Saturated Connections : Set the number for saturation whenever session numbers reach it, the CS-1000
switches to the next WAN port on the list. This function is only applicable for By Session mode.
Ping / HTTP : Display Ping/HTTP functions of WAN 1/2 to show if they are enabled or disabled.
Configure : Click Modify to modify WAN 1/2 settings.
Priority : Set priority of WAN 1/2 for Internet Access.
WAN 1/2 Interface
Using the WAN 1/2 Interface, the Administrator can sets up the WAN 1/2 network. These IP addresses are
real public IP Addresses, and are routable on the Internet.
Alive Indicator Site IP: This feature is used to ping an address for detecting WAN connection status.
Service: ICMP You can select an IP address by Assist, or type an IP address manually.
Service: DNS You can select a DNS IP and Domain name by Assist, or type the related data manually.
PPPoE (ADSL User): This option is for PPPoE users who are required to enter a username and password in
order to connect.
Username: Enter the PPPoE username provided by the ISP.
Password: Enter the PPPoE password provided by the ISP.
IP Address provided by ISP:
Dynamic: Select this if the IP address is automatically assigned by the ISP.
Fixed: Select this if you were given a static IP address. Enter the IP address that is given to you by
your ISP.
Max. Upstream/Downstream Bandwidth: The bandwidth provided by ISP.
Auto Disconnect : The PPPoE connection will automatically disconnect after a length of idle time (no
activities). Enter in the amount of idle minutes before disconnection. Enter ‘0’ if you do not want the
PPPoE connection to disconnect at all.
Ping: Select this to allow the WAN 1 network to ping the IP Address of the Multi-Homing Security
Gateway. This will allow people from the Internet to be able to ping the Multi-Homing Security Gateway. If
it sets to enable, the device will respond to echo request packets from the WAN 1/2 network.
HTTP: Select this to allow the device WEBUI to be accessed from the WAN 1 network. This will allow
WebUI to be configured from a user on the Internet. Keep in mind that the device always requires a
username and password to enter the WebUI.
- 36 -